Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Doi, Daisuke
Proceedings of 29th International Conference on Nuclear Engineering (ICONE 29) (Internet), 7 Pages, 2022/08
Shinozaki, Takashi; Mihara, Takeshi; Udagawa, Yutaka; Sugiyama, Tomoyuki; Amaya, Masaki
JAEA-Research 2014-025, 34 Pages, 2014/12
JAEA-Research-2014-025.pdf:6.05MB
EDC test is a test method on the mechanical property of fuel cladding tube, and it focuses on the stress condition generated by PCMI under a RIA. We conducted EDC tests which simulate the mechanical conditions during a RIA by using the unirradiated cladding tubes which simulate hydride rim. Circumferential residual strains observed in post-test specimens tended to decrease with increasing the hydrogen concentration in the test cladding tubes and the thickness of the hydride rim. We also prepared RAG tube and performed EDC tests on it. It was observed that circumferential total strains at failure tended to decrease with increasing pre-crack depth on the outer surface of RAG tube specimen. We conducted biaxial stress tests by applying longitudinal tensile load onto RAG tube specimens. It was observed that circumferential total strains at failure under biaxial stress conditions tended to decrease compared to the results under uniaxial tensile condition.
Nagase, Fumihisa; Fuketa, Toyoshi
Journal of Nuclear Science and Technology, 42(1), p.58 - 65, 2005/01
Times Cited Count：47 Percentile：93.51(Nuclear Science & Technology)Tube burst tests have been performed with artificially hydrided Zircaloy-4 specimens at room temperature and at 620 K. Pressurization rate was increased to a maximum of 3.4 GPa/s in order to simulate rapid PCMI that occurs in high burnup fuel rods during a pulse-irradiation in the NSRR. Hydrogen content in the specimens ranged from 150 to 1050 ppm. Hydrides were accumulated in the cladding periphery and formed "hydride rim" as observed in high burnup PWR fuel claddings. The hydrided cladding tubes failed with an axial crack at the room temperature tests. Brittle fracture appeared in the hydride rim, and failure morphology was similar to that observed in the NSRR experiments. The hydrides rim obviously reduced burst pressure and residual hoop strain at the tests. The residual hoop strain was very small even at 620 K when thickness of the hydride rim exceeded 18% of cladding thickness. The present result accordingly indicates an important role of the hydrides layer in high burnup fuel rod failure under RIA conditions.
